Wireless/Redundant Edge Services xl Module Management and Configuration Guide WS.01.03 or greater

2-6
Configuring the ProCurve Wireless Services xl Module
Management Interfaces
Replace <slot letter> with the letter for the chassis slot in which the Wireless
Edge Services xl Module is installed. For example, if the module is installed
in chassis slot C, you would enter:
ProCurve(config)# wireless-services c
Determine the IP Address Assigned by the DHCP Server. If the Wire-
less Edge Services xl Module receives an IP address through a DHCP server,
enter:
ProCurve(wireless-services-C)# show ip interface
The IP address assigned to the default management interface is listed.
Assign a Static IP Address. If you want to assign a static IP address to the
Wireless Edge Services xl Module, move to the global configuration context
and enter the following commands:
ProCurve(wireless-services-C)# configure terminal
ProCurve(wireless-services-C) (config)# interface vlan1
ProCurve(wireless-services-C) (config-if)# ip address <A.B.C.D></prefix length>]
Replace <A.B.C.D> with the IP address that you want to assign the Wireless
Edge Services xl Module. Replace </prefix length> with the Classless Inter-
Domain Routing (CIDR) notation. Do not include a space between the IP
address and the prefix length.
To specify a default gateway for the Wireless Edge Services xl Module, exit to
the global configuration context and enter:
ProCurve(wireless-services-C) (config)# ip default-gateway <A.B.C.D>
Replace <A.B.C.D> with the IP address of the default gateway.
Accessing the Web Browser Interface
You can access the Web browser interface in one of two ways:
■ Enter the IP address assigned to the Wireless Edge Services xl Module as
the URL in your Web browser
■ Access the Web browser interface for the wireless services-enabled
switch