Wireless/Redundant Edge Services xl Module Management and Configuration Guide WS.01.03 or greater

2-9
Configuring the ProCurve Wireless Services xl Module
Management Interfaces
Figure 2-3. Example of a Configuration Screen
Applying or Saving Changes
When you use the Web browser interface to configure the Wireless Edge
Services xl Module, these changes may affect two configuration files, depend-
ing on if you apply or save changes:
■ startup-config—When you save changes, these changes become part of
the startup-config file, which is stored in non-volatile RAM (NVRAM) on
the module’s internal flash. When the Wireless Edge Services xl Module
is rebooted, all the configurations that are contained in the startup-config
file are retained. During the reboot process, the module initializes the
designated boot image software and then loads the startup-config.
■ running-config—When the Wireless Edge Services xl Module loads the
startup-config, all the configurations become part of the running-config,
which is held in RAM. When you make and apply configuration changes
in the Web browser interface, these changes become part of the running-
config as well. If you do not save the changes that you apply to the running-
config, these changes are not retained when the Wireless Edge Services
xl Module is rebooted.