Wireless/Redundant Edge Services xl Module Management and Configuration Guide WS.01.03 or greater

2-12
Configuring the ProCurve Wireless Services xl Module
Management Interfaces
From the Help Navigator screen, you can select one of the following tabs:
■ Content—The Content tab provides a list of available topics. You simply
double click a topic to view the Help information.
■ Search—The Search tab allows you to enter keywords or boolean expres-
sions to find all the information about a specific topic. When the results
of the search are listed, select one of the topics and click the Open button
to view the Help information.
CLI
To manage the Wireless Edge Services xl Module from the CLI, you must first
access the CLI for the wireless services-enabled switch. You can access the
switch’s CLI through:
■ Serial session
■ Telnet session
■ SSH session
Accessing the CLI Through a Serial Session
If you use a serial session to connect to the wireless services-enabled switch,
use the serial cable (5184-1894) that was shipped with the switch. Then run
terminal session software such as Tera Term or HyperTerminal on your
workstation, setting the following parameters for the session:
■ Baud Rate = 9600
■ Parity = None
■ Data Bits = 8
■ Stop Bits = 1
■ Flow Control = None
When you are prompted for a password, enter the password for the manager
user on the wireless services-enabled switch.
Accessing the Wireless-Services Context
To begin configuring the Wireless Edge Services xl Module, you must move to
the wireless-services context in the switch’s CLI. In essence, the wireless-
services context is a subset of the switch’s CLI.
To access the wireless-services context, you must first move to the global
configuration context in the switch’s CLI:
ProCurve# configure terminal