Wireless/Redundant Edge Services xl Module Management and Configuration Guide WS.01.03 or greater

2-13
Configuring the ProCurve Wireless Services xl Module
Management Interfaces
Then, enter:
ProCurve(config)# wireless-services <slot letter>
Replace <slot letter> with the letter for the chassis slot in which the Wireless
Edge Services xl Module is installed. For example, if the module is installed
in slot C, you would enter:
ProCurve(config)# wireless-services c
The CLI prompt shows that you are in the wireless-services context.
ProCurve(wireless-services-C)#
The wireless-services context allows you to configure and manage the Wire-
less Edge Services xl Module. The wireless-services context is organized into
the same contexts used in the switch’s CLI. When you first access the wireless-
services context, you are at the enable context, which is identified by the #
symbol that follows the “(wireless-services-C)” portion of the prompt.
From the enable context, you can enter show commands to view information
about the Wireless Edge Services xl Module, and you can perform some
operations such as erasing the startup-config file and copying configuration
files to and from the module.
To make most configuration changes, however, you must move to the global
configuration context. From the global configuration context, you can enter
commands to change settings, or you can access other contexts that allow you
to change settings.
To move to the global configuration context for wireless services, enter:
ProCurve(wireless-services-C)# configure terminal
Again, the CLI prompt shows your new context:
ProCurve(wireless-services-C) (config)#
To view the commands available at any context, you can use a question mark:
ProCurve(wireless-services-C) (config)# ?
You can also use the question mark to view the options available for specific
commands:
ProCurve(wireless-services-C) (config)# ip ?