Wireless/Redundant Edge Services xl Module Management and Configuration Guide WS.01.03 or greater

2-17
Configuring the ProCurve Wireless Services xl Module
Network Services Manager
information in its route table. In the example shown in Figure 2-6, the default
management interface (which is, in this case, VLAN 1) is directly connected
to network 192.168.1.0 /24.
Figure 2-6. Network Setup > Internet Protocol > IP Forwarding Screen
If you assign an IP address to any other VLAN (as described in “IP Address
Management” on page 2-20), the Wireless Edge Services xl Module recognizes
the subnetwork attached to that VLAN and lists it as a directly connected
route.
To view the module’s route table, click Network Setup > Internet Protocol and
select the IP Forwarding tab. (See Figure 2-6.) The following fields are provided
for each route:
■ Destination Subnet—lists the IP address of the destination subnetwork.
■ Subnet Mask—lists the subnet mask for the destination subnetwork.
■ Gateway Address—lists the gateway for reaching the destination sub-
network.
■ Interface—lists the VLAN through which traffic is forwarded.