Wireless/Redundant Edge Services xl Module Management and Configuration Guide WS.01.03 or greater

2-19
Configuring the ProCurve Wireless Services xl Module
Network Services Manager
Note If you want to add a default route, enter 0.0.0.0 for both the Destination Subnet
field and the Subnet Mask field. A default route is a special static route that
can be applied to all traffic. Typically, when a router or a Layer 3 switch
receives a packet that it does not know how to forward, it drops that packet.
A default route allows the Wireless Edge Services xl Module to forward all
such packets toward the destination most likely to be able to route them.
5. In the Gateway Address field, enter the IP address of the gateway.
6. Click OK to apply the change to the running-config.
7. Click the Save button at the bottom of the navigation bar to save the
changes to the startup-config.
Address Resolution Table
The Wireless Edge Services xl Module maintains an address resolution table,
which displays the media access control (MAC) address for Layer 3 inter-
faces—interfaces that have been assigned IP addresses.
To view this table, click Network Setup > Internet Protocol and select the
Address Resolution tab.
Figure 2-8. Network Setup > Internet Protocol > Address Resolution Screen