Wireless/Redundant Edge Services xl Module Management and Configuration Guide WS.01.03 or greater

2-25
Configuring the ProCurve Wireless Services xl Module
Network Services Manager
Figure 2-12. Network Setup > Ethernet > Statistics Screen
You can view the following information:
■ Name—VLAN ID (also referred to as the interface).
■ Bytes In—total number of bytes received on the interface.
■ Packets In—total number of packets received on the interface, including
packets dropped and error packets.
■ Packets In Dropped—number of incoming packets that are dropped.
Packets might be dropped if the input queue is saturated or if an overrun
occurs (the interface receives packets faster than it can transfer them to
a buffer).
■ Packets In Error—number of incoming packets with errors such as:
• Runt frames—Runt frames are smaller than the minimum Ethernet
frame of 64 bytes.
• Cyclic Redundancy Check (CRC) errors—CRC errors are
reported if the receiving station computes a CRC value that does not
match the 4-byte CRC field at the end of the Ethernet frame.
• Late collisions—A late collision occurs after the sending station
sends the first 64 octets of data.