Wireless/Redundant Edge Services xl Module Management and Configuration Guide WS.01.03 or greater

2-31
Configuring the ProCurve Wireless Services xl Module
Radio Port Adoption
In addition to creating the default Radio Port VLAN, the wireless services-
enabled switch automatically configures the module’s downlink port as a
tagged member of VLAN 2100. The downlink port handles the traffic sent to
and from RPs.
If you attach RPs to a PoE module that is installed in the wireless services-
enabled switch, the switch automatically configures each RP’s switch port as
an untagged member of the default Radio Port VLAN. (Because the RP does
not support 802.1Q, it must be an untagged member of the Radio Port VLAN.)
When the appropriate VLAN memberships are established, the RPs can trans-
mit traffic to the Wireless Edge Services xl Module, and the module can, in
turn, detect the RPs. (See Figure 2-17.) (For more information about the
communications between the RPs and the wireless services-enabled switch,
see Chapter 1: Introduction.)