Wireless/Redundant Edge Services xl Module Management and Configuration Guide WS.02.xx and greater

2-85
Configuring the ProCurve Wireless Edge Services xl Module
System Maintenance
6. In the Port field, if needed, change the port number for your FTP or TFTP
server. In most cases, the defaults (port 21 for FTP, port 69 for TFTP)
should apply to your server.
7. In the IP Address field, enter the IP address of the FTP or TFTP server.
8. If you are using an FTP server, enter the login credentials for that server.
a. In the User ID field, enter the username.
b. In the Password field, enter the password for this username.
9. In the Path field, enter the path where the new image file is saved. If you
are using an FTP server and the image file is saved at the server’s root
level, enter a period followed by a slash (./). If the image file resides at a
different level on the FTP server, enter the complete path. (If you are using
a TFTP server, this field may not be required.)
10. Click the Do Upgrade button.
Configuration Files
The Wireless Edge Services xl Modules ships with a factory default startup-
config file. Factory default settings include:
■ support for HTTP and HTTPS
■ support for SNMP v1, v2, and v3
■ DHCP-assigned IP address for the default management interface (VLAN 1)
As you configure the Wireless Edge Services xl Module and save changes,
these changes are saved to the startup-config. From the Web browser inter-
face, you can view the commands included in the startup-config file, or you
can return the startup-config file to factory default settings.
For backup purposes, you can save the startup-config file to:
■ FTP server
■ TFTP server
■ workstation’s hard disk
In addition, you can save multiple configuration files and store them in the
module’s internal flash. As Table 2-2 shows, configuration files are stored in
two locations in the module’s internal flash.