ProLiant BL p-Class GbE Interconnect Switch Command Line Interface Reference Guide

Configuring the GbE Interconnect Switch using the Command Line Interface
Use the following command to configure the SNMP management interface community
strings:
Command Description
snmp add
{
string community <string> access {ro | rw}]
|
trap ip <ip_addr> community <string>
}
Configures the SNMP interface with up to
four sets of community strings with access
rights and access validity status and
configures up to four (one at a time) SNMP
trap manager IP addresses
Type one of the following in the command:
• string —To define a community string,
type string and the following:
• community <string>—Type
community and a string from 1 to
20 characters in length. This string
is included on SNMP packets sent
to and from the GbE Interconnect
Switch. Any station not privy to this
community does not receive the
packet.
• access {ro | rw}—Type access
and either ro (read only), meaning
that the community member can
only view switch settings, or rw
(read-write) which allows the
member to change settings on the
GbE Interconnect Switch.
• trap—To configure an SNMP trap IP
address, type trap and the following:
• ip <ip_addr>— Type ip and IP
address of the trap recipient.
• community <string>—Type
community and a string from 1 to
20 characters in length.
HP ProLiant BL p-Class GbE Interconnect Switch Command Line Interface Reference Guide 2-85