ProLiant BL p-Class GbE Interconnect Switch Command Line Interface Reference Guide

Configuring the GbE Interconnect Switch using the Command Line Interface
HP ProLiant BL p-Class GbE Interconnect Switch Command Line Interface Reference Guide 2-91
Performing a Ping Test
Use the following command to run the ping utility:
Command Description
ping <ip_addr>
[<repeat>]
Pings the targ
et IP address and repeats pinging
infinitely or a s
pecified number of times
Type the target IP address in the command. To
specify the number of times to pin
g, type a
number from 0 to 244. Zero (0) means an
infinite number of times. The default is 1.
Press the ESC key to stop the ping.
Rebooting the GbE Interconnect Switch
Use the following command to reboot the switch:
Command Description
reboot
[ {cfg-save | load-def | save-ip-load-def} ]
Reboots the GbE Interconnect Switch
To save the configuration, type one of the
followi
ng in the command:
• cfg-save—Type cfg-save to save the
current configuration settings and reboot
the GbE Interconnect Switch.
• load-def—Type load-def to reboot the
GbE Interconnect Switch to the factory
default configuration settings.
• save-ip-load-def—Type save-ip-load-def
to reboot the GbE Interconnect Switch to
the factory default configuration settings.
This option allows the switch to retain its
last IP address.
Logging Out
Use the following command to exit the current CLI session:
Command Description
logout
Logs the user out of the current CLI session