ProLiant BL p-Class GbE Interconnect Switch Command Line Interface Reference Guide

Overview
1-12 HP ProLiant BL p-Class GbE Interconnect Switch Command Line Interface Reference Guide
Paging of Data Output
You can configure the switch module to display one page of data at a time. This is helpful
when you are in a Telnet session and are using the show commands to display information
about the switch.
Paging is on with every new CLI session. To avoi
d the paging prompts when using scripts,
set paging to off.
Use the following command to set the paging option:
Command Description
paging {on | off}
Configures the switch to display one page of data at a time
If paging is turned off, data will display continuously until the
end of the d
ata is reached.
Configuring the GbE Interconnect Switch
After logging on to the GbE Interconnect Switch for the first time, perform the following
tasks:
•
•
•
Configure the IP address
Set up users, passwords, and access privileges
Change default SNMP community strings for read/write and read-only
For information on how to configure these and other GbE Interconnect switch features, refer
to Chapter 2.
NOTE: After configuring the IP address on the GbE Interconnect Switch, the GbE Interconnect Switch
can be accessed using Telnet, SNMP, or a Web browser. Refer to the section, “Configuring the
Remote Management IP Interface Settings,” in Chapter 2 for information on how to set up the IP
address.