ProLiant BL p-Class GbE Interconnect Switch Command Line Interface Reference Guide

Configuring the GbE Interconnect Switch using the Command Line Interface
Use the following command to configure the remote management IP interface settings:
Command Description
mgmt-if set
{
[mode {manual | bootp | dhcp}]
[ipaddr <ip_addr>]
[netmask <subnet_mask>]
[def-gateway <ip_addr>]
[mvid <vlan_id>]
[secure-ip <iplist> ]
}
Sets the remote management parameters
including:
• mode {manual | bootp | dhcp}—Type
mode and manual, bootp, or dhcp. The
default is dhcp.
If you choose manual, type the following:
• ipaddr <ip_addr>—Type ipaddr and
the IP address in the form of
xxx.xxx.xxx.xxx, where each xxx is a
number between 0 and 255.
• netmask <subnet_mask>—Type
netmask and 255.0.0.0 for a Class A
network, 255.255.0.0 for a Class B
network, 255.255.255.0 for a Class C
network, or type a custom subnet
mask.
• def_gateway <ip_addr>—Type
def-gateway and the IP address that
determines where packets with a
destination address outside the
current subnet should be sent.
• mvid <vlan_id>—Management VLAN ID
(MVID) is the VLAN ID of the management
processor port. Type mvid and the VLAN
ID through which you want to access the
GbE Interconnect Switch management
interface.
• secure-ip <iplist>—Type secure-ip and
the management station IP addresses that
are allowed to access the switch
management interface. Enter from one to
eight addresses, separated by commas.
HP ProLiant BL p-Class GbE Interconnect Switch Command Line Interface Reference Guide 2-7