ProLiant BL p-Class GbE Interconnect Switch Command Line Interface Reference Guide

Configuring the GbE Interconnect Switch using the Command Line Interface
— SNTP Status— Displays the Simple Network Time Protocol (SNTP) status set on
the switch. SNTP allows the switch to synchronize its real time to the network time.
When SNTP is enabled, the interconnect switch sends a request to a primary SNTP
server in each period of a specified polling interval asking for the Greenwich Mean
Time (GMT). If the primary SNTP server is not available, the request is sent to a
secondary SNTP server. For additional information, refer to the “Configuring GbE
Interconnect Switch Date and Time” section later in this chapter.
— SNTP Server1 IP—Displays the IP address for the primary SNTP server the GbE
Interconnect Switch can use.
— SNTP Server2 IP—Displays the IP address for the secondary SNTP server the GbE
Interconnect Switch can use.
— SNTP Poll Interval—Displays the polling interval set on the GbE Interconnect
Switch to synchronize with the network time.
— Time Zone—Displays the number of hours and minutes that the time zone is ahead
(+) or behind (-) Greenwich Mean Time (GMT).
— Daylight Saving Time State—Displays if daylight saving time settings are enabled
or disabled on the GbE Interconnect Switch.
— Daylight Saving Time Start Month, Week, Day—Displays the month, week, and
day that daylight saving time is set to start.
— Daylight Saving Time End Month, Week, Day—Displays the month, week, and
day that daylight saving time is set to end.
Configuring Auto-Logout Timer
The auto-logout timer sets the time the RS-232 console and Telnet management interfaces
can be idle before the GbE Interconnect Switch automatically logs out the user.
The following shows the factory default setting for the auto-logout timer:
Feature Default Value
Auto Logout 10 minutes
Setting the Auto-Logout Time
Use the following command to set the auto-logout time:
Command Description
auto-logout set time-out {0 | 2 | 5 | 10 | 15}
Sets the auto-logout timer for idle timeout of the
RS-232 console and Telnet management
interface sessions. The options are: 0, 2, 5, 10,
and 15 minutes. Zero (0) indicates never timing
out.
HP ProLiant BL p-Class GbE Interconnect Switch Command Line Interface Reference Guide 2-13