ProLiant BL p-Class GbE Interconnect Switch Command Line Interface Reference Guide

Configuring the GbE Interconnect Switch using the Command Line Interface
Modifying IGMP Settings for a VLAN
Use the following command to modify the IGMP settings for a VLAN:
Command Description
igmp modify vlan <vlan_id>
{
[state {non | v1 | v2}]
[robustness <robustness>]
[interval <query_interval>]
[response <response>]
}
Modifies the parameters for a specified VLAN in
the IGMP snooping table
Type the VLAN ID and one or more of the
following in the command:
• state {non | v1 | v2} —Specifies the IGMP
version (V1 or V2) that is used by the IGMP
interface when making queries. Type state
and one of the querier-state options:
• non—non-querier
• v1—version 1 querier
• v2—version 2 querier
• robustness <robustness>—Provides a
tuning variable that allows for subnetworks
that are expected to lose a large number of
packets. Type robustness and a value
from 2 to 225, with larger values being
specified for subnetworks that are expected
to lose larger numbers of packets. The
default is 2.
• interval <query_interval>—Specifies the
length of time between sending IGMP
queries. Type interval and a value from 1
to 65500 seconds. The default is 125.
• response <response>—Sets the maximum
amount of time allowed before sending an
IGMP response report. Type response and
a value from 1 to 25 seconds. The default
is 10.
2-22 HP ProLiant BL p-Class GbE Interconnect Switch Command Line Interface Reference Guide