ProLiant BL p-Class GbE Interconnect Switch Command Line Interface Reference Guide

Configuring the GbE Interconnect Switch using the Command Line Interface
Disabling SNTP
Use the following command to disable SNTP on the GbE Interconnect Switch:
Command Description
sntp disable
Disables SNTP
SNTP must be set to disable in order to
manually set the time and date.
Configuring Port Settings
The port commands allow you to configure the name, speed/duplex, flow control, and
security settings for each port.
Speed/Duplex Settings
The speed-duplex parameter for each port can be set to 1000M/Full, 100M/Full, 100M/Half,
10M/Full, 10M/Half, or Auto. The Auto setting allows the port to automatically determine
the fastest setting that the device to which the port is connected can handle.
IMPORTANT: In the forced 100M/Full, 100M/Half, 10M/Full, and 10M/Half modes, auto MDI-X is
disabled and a cross-over cable must be used.
IMPORTANT: If you have the ProLiant BL p-Class F-GbE Interconnect Kit option with the DualTSX
Interconnect Modules, the management interface supports only 1000M/Full and Auto options for the
speed/duplex settings for Gigabit uplink ports. The fiber Dual TSX Interconnect Module supports only
1000-Mb/s (Gigabit) speed, and not 10-Mb/s or 100-Mb/s.
HP ProLiant BL p-Class GbE Interconnect Switch Command Line Interface Reference Guide 2-43