ProLiant BL p-Class GbE Interconnect Switch Command Line Interface Reference Guide

Configuring the GbE Interconnect Switch using the Command Line Interface
Setting Port Parameters
Use the following command to set the port parameters:
Command Description
port set
{
label port <port#> name <name> |
params port <portlist>
{
[speed-duplex {auto | 10-half | 10-full |
100-half | 100-full | 1000-full}] |
[flow-control {on | off}]
} |
security port <portlist> learn <max#> mode
{timeout | reset}
}
}
Configures the port names, port parameters,
and port security parameters
Type one of the following in the command:
• label—Sets the port name. Type label
and the following:
• port <port#>—Type port and the
port number.
• name <name>—Type name and a
character string description for the
port. 1-15 characters are allowed.
• params—Sets the port parameters. Type
params and the following:
• port <portlist>—Type port and the
port number or numbers, and one or
both of the following:
• speed-duplex {auto | 10-half |
10-full| 100-half | 100-full |
1000-full}—Type speed-duplex
and one of the speed-duplex
options.
IMPORTANT: If the ports are
Gigabit fiber, the only speed-
duplex options are auto and
1000-full.
• flow-control {on | off}—Type
flow-control and either on or
off.
• security—Sets the port security
parameters. Type security and the
following:
• port <portlist>—Type port and the
port number or numbers.
• learn <max#>—Type learn and the
maximum number of addresses that
can be learned at this port. A number
from 0 to 10 is allowed.
• mode {timeout | reset}—Type
mode and either timeout or reset.
HP ProLiant BL p-Class GbE Interconnect Switch Command Line Interface Reference Guide 2-45