ProLiant BL p-Class GbE Interconnect Switch Command Line Interface Reference Guide

Configuring the GbE Interconnect Switch using the Command Line Interface
Adding Unicast Filter Actions
The GbE Interconnect Switch supports unicast filtering for static forwarding control. Packets
are forwarded to a specific destination port (allow-to-go port) for a specific unicast
destination address.
Use the following command to add unicast filter actions:
Command Description
unicast add
vlan <vlan_id>
mac <mac_addr>
type {permanent | delete-on-reset}
port <port#>
Enables unicast filter actions
Type the following in the command:
• vlan <vlan_id>—Type vlan and the VLAN
ID.
• mac <mac_addr>—Type mac and the
MAC address.
• type {permanent | delete-on-reset}—
Type type and one of the following filter
types:
• permanent—The filter stays
permanently until reconfigured.
• delete-on-reset—The filter is deleted
when the port is reset.
• port <port#>—Type port and the
destination (allow-to-go) port number.
HP ProLiant BL p-Class GbE Interconnect Switch Command Line Interface Reference Guide 2-59