ProLiant BL p-Class GbE Interconnect Switch Web-based Interface Reference Guide

Configuring the GbE Interconnect Switch using the Web-based Interface
5. Click Apply.
IMPORTANT: To save the configuration settings permanently, they must be entered into NVRAM
using the Save Changes option on the Maintenance menu. Refer to the section, “Saving
Changes,” earlier in this chapter.
Configuring Advanced GbE Interconnect Switch Features
You can configure advanced switch features including global settings for IGMP snooping,
GVRP, Telnet status, Web status, SNTP, and others.
To configure advanced GbE Interconnect Switch features:
1. Select Advanced Settings from the Configuration menu. The following screen is
displayed.
You can change the following parameters:
— Auto Logout of Telnet/RS232 Interface—Select the time that the RS-232 console
and Telnet management interface can be idle before the GbE Interconnect Switch
automatically logs-out the user: 2 minutes, 5 minutes, 10 minutes, 15 minutes, and
Never. Never indicates never timing out. The default is 10 minutes.
— MAC Address Aging Time—Select the length of time a learned MAC address
remains in the forwarding table without being seen as a source (that is, how long a
learned MAC address is allowed to remain idle before deleting from the address
table). The aging time can be set to any value between 1 and 1,000,000 seconds.
HP ProLiant BL p-Class GbE Interconnect Switch Web-based Interface Reference Guide 2-9