ProLiant BL p-Class GbE Interconnect Switch Web-based Interface Reference Guide

Configuring the GbE Interconnect Switch using the Web-based Interface
• If the IGMP snooping configuration for any port trunk member is changed, the IGMP
snooping settings for all port trunk members are changed.
•
•
The port trunk takes precedence over any other setting. That is, the settings of trunked
ports are the same as the master port settings.
When any trunked port becomes a non-trunked port, all of the port configurations are
reset to default settings.
Refer to Appendix H in the HP ProLiant p-Class GbE Interconnect Switch User Guide for
additional information on port trunking.
To configure port trunking:
1. Select Port trunking from the Configuration menu. The following screen is displayed.
2. Type a user-assigned name in the Name field.
3. In the Member Ports area, check the ports that will compose the port trunk.
4. Change the State field to Enabled.
5. Click Apply.
IMPORTANT: To save the configuration settings permanently, you must enter them into NVRAM
using the Save Changes option on the Maintenance menu. Refer to the section, “Saving
Changes,” earlier in this chapter.
2-16 HP ProLiant BL p-Class GbE Interconnect Switch Web-based Interface Reference Guide