ProLiant BL p-Class GbE Interconnect Switch Web-based Interface Reference Guide

Configuring the GbE Interconnect Switch using the Web-based Interface
Configuring Port Security
To configure port security for a port or range of ports:
1. Select Port Security from the Configuration menu. The following screen is displayed.
2. Select the range of ports in the From and To fields.
3. Select Enabled in the Admin State field.
4. Type the maximum number of addresses in the Max. Address field.
5. Select the Mode that you want, either DeleteOnTimeout or DeleteOnReset.
6. Click Apply to apply your settings.
IMPORTANT: To save the configuration settings permanently, you must enter them into NVRAM
using the Save Changes option on the Maintenance menu. Refer to the section, “Saving
Changes,” earlier in this chapter.
HP ProLiant BL p-Class GbE Interconnect Switch Web-based Interface Reference Guide 2-37