ProLiant BL p-Class GbE2 Interconnect Switch Application Guide

VLANs 48
Figure 5 802.1Q tagging (after port-based VLAN assignment)
In the following figure, the tagged incoming packet is assigned directly to VLAN 2 because of the tag assignment
in the packet. Port 5 is configured as a tagged member of VLAN 2, and port 7 is configured as an untagged
member of VLAN 2.
Figure 6 802.1Q tag assignment
As shown in the following figure, the tagged packet remains unchanged as it leaves the GbE2 Interconnect
Switch through port 5, which is configured as a tagged member of VLAN 2. However, the tagged packet is
stripped (untagged) as it leaves the GbE2 Interconnect Switch through port 7, which is configured as an
untagged member of VLAN 2.
Figure 7 802.1Q tagging (after 802.1Q tag assignment)
NOTE: Using the /boot/conf factory command resets all ports to VLAN 1 and all other settings to the
factory defaults at the next reboot.