ProLiant BL p-Class GbE2 Interconnect Switch Browser-based Interface Reference Guide

Configuring the switch 111
Table 89 Switch Management Processor Configuration (SNMP) controls
Control Description
Send SNMP Auth. Failure Traps? Enables or disables the use of the system authentication trap facility. The
default setting is disabled.
Switch Management Processor Configuration buttons
The following table describes the Switch Management Processor Configuration buttons:
Table 90 Switch Management Processor Configuration buttons
Control Description
Submit Sends this form to the GbE2 Interconnect Switch. Any configuration changes are placed in the
“pending” state and do not take effect until the toolbar Apply command is given.
Diff Shows any pending configuration changes.
Diff Flash Compares new configuration with the flash configuration.
Revert Removes pending configuration changes between apply commands. Use this command to
restore configuration parameters set since last apply command.
Revert Apply Removes pending configuration changes between save commands. Use this command to
restore configuration parameters set since last save command.
User Configuration Table
To display the following form, select System > User Table.
This form summarizes the users configured on the GbE2 Interconnect Switch. Click Add User to define a new
user. Click Change User/Oper/Admin password to configure new passwords for the switch.