ProLiant BL p-Class GbE2 Interconnect Switch Browser-based Interface Reference Guide

Configuring the switch 113
Switch RADIUS Configuration
To display the following form, select System > Radius.
The following table describes Switch Radius Configuration controls:
Table 92 Switch RADIUS Configuration controls
Control Description
Primary Radius IP Address Configures the primary Radius server address.
Secondary Radius IP Address Configures the secondary Radius server address.
Radius port (1500-3000) Configures the number of the UDP port to be configured, between 1500 -
3000. The default is 1645.
Radius timeout (1-10) Configures the amount of time, in seconds, before a Radius server
authentication attempt is considered to have failed. The default is 3 seconds.
Radius retries (1-3) Configures the number of failed authentication requests before switching to a
different Radius server. The default is 3 requests.
Enable/Disable Radius Server Enables or disables the Radius server.
Enable/Disable Radius Backdoor for telnet Enables or disables the RADIUS back door for telnet/SSH/ HTTP/HTTPS.
This command does not apply when secure backdoor is enabled.
Enable/Disable Radius Secure Backdoor for
telnet
Enables or disables the RADIUS back door using secure password for
telnet/SSH/ HTTP/HTTPS.
Radius Secret Defines the shared secret (up to 32 characters) between the switch and the
RADIUS server(s).
Secondary Radius Server Secret Defines the secondary shared secret (up to 32 characters) between the
switch and the Radius server(s).