ProLiant BL p-Class GbE2 Interconnect Switch Browser-based Interface Reference Guide

Configuring the switch 150
LACP Port Configuration
To display the following form, go to the Switch LACP Configuration form. Select a port number.
The following table describes the LACP Port Configuration controls:
Table 124 LACP Port Configuration controls
Control Description
Port Admin Key Set the admin key for this port. Only ports with the same admin key and oper key (operational state
generated internally) can form a LACP trunk group.
Port Priority Sets the priority value for the selected port. Lower numbers provide higher priority. Default is 128.
Port LACP Mode Set the LACP mode for this port, as follows:
• off: Turn LACP off for this port. You can use this port to manually configure a static trunk. The default
value is off.
• active: Turn LACP on and set this port to active. Active ports initiate LACPDUs.
• passive: Turn LACP on and set this port to passive. Passive ports do not initiate LACPDUs, but
respond to LACPDUs from active ports.
Uplink Fast Configuration
To display the following form, select Layer 2 > UpLink Fast.