ProLiant BL p-Class GbE2 Interconnect Switch Browser-based Interface Reference Guide

Configuring the switch 161
The following table describes Network Filters Configuration controls:
Table 137 Network Filters Configuration controls
Control Description
Search Operation To focus the search for a network filter, enter optional search parameters:
• Network Filter ID
• IP address and subnet mask
• State
Fields that have a value of “any” are ignored during the search.
Choose a search operation:
• or: Search for network filters specified in the Search range that meet any of the criteria
entered.
• and: Search for network filters specified in the Search range that meet all of the criteria
entered.
Click Search to display network filters that fit the range and meet the criteria entered.
Network Filter Configuration
To display the following form, go to the Network Filters Configuration form. Select a network filter ID number, or
open the Network Filters folder and click Add Network Filter.
The following table describes the Network Filter Configuration controls:
Table 138 Network Filter Configuration controls
Control Description
Network Filter Identifier (1-256) Sets the numeric identifier for this network filter.
IP Address Sets the starting IP address for this filter. The default address is 0.0.0.0
Enabled? Enables or disables the Network Filter configuration.
Subnet Mask Sets the IP subnet mask that is used to define the range of IP addresses that will be
accepted by the peer when the filter is enabled. The default value is 0.0.0.0