ProLiant BL p-Class GbE2 Interconnect Switch Browser-based Interface Reference Guide

Configuring the switch 185
The following table describes Virtual Routers Configuration controls:
Table 163 Virtual Routers Configuration controls
Control Description
Search Operation To focus the search for an virtual router, enter search parameters:
• Virtual Router number
• IP Address
• Virtual Router state
Fields that have a value of “any” are ignored during the search.
Choose a search operation:
• or: Search for virtual routers specified in the Search range that meet any of the criteria
entered.
• and: Search for virtual routers specified in the Search range that meet all of the criteria
entered.
Click Search to display virtual routers that fit the range and meet the criteria entered.
Virtual Router Configuration
To display the following form, go to the Virtual Routers Configuration form. Select a Virtual Router number or
open the Virtual Routers folder and click Add Virtual Router.
The following table describes the Virtual Router Configuration controls:
Table 164 Virtual Router Configuration controls
Control Descriptions
Virtual Router Identifier (1-255) Defines the virtual router ID. This is used in conjunction with addr (below) to define a
virtual router on this switch. To create a pool of VRRP-enabled routing devices which can
provide redundancy to each other, each participating VRRP device must be configured
with the same virtual router: one that shares the same
vrid and addr combination.
The
vrid for standard virtual routers (where the virtual router IP address is not the same
as any virtual server) can be any integer between 1 and 255. The default value is 1.
All
vrid values must be unique within the VLAN to which the virtual router’s IP interface
belongs.