ProLiant BL p-Class GbE2 Interconnect Switch ISCLI Reference Guide

Configuration Commands 100
Table 104 802.1x Global Configuration commands
Command Description
dot1x server-timeout {<1-65535>} Sets the time, in seconds, the authenticator waits for a response from the
RADIUS server before declaring an authentication timeout. The default
value is 30 seconds.
Command mode: Interface port
dot1x max-request {<1-10>} Sets the maximum number of times the authenticator retransmits an EAP-
Request packet to the supplicant (client). The default value is 2.
Command mode: Interface port
dot1x re-authentication-interval
{<1-604800>}
Sets the time, in seconds, the authenticator waits before re-
authenticating a supplicant (client) when periodic re-authentication is
enabled. The default value is 3600 seconds.
Command mode: Interface port
[no] dot1x re-authenticate Sets the re-authentication status to on or off. The default value is off.
Command mode: Interface port
default dot1x Resets the global 802.1x parameters to their default values.
Command mode: Interface port
show dot1x Displays current global 802.1x parameters.
Command mode: All
Rapid Spanning Tree Protocol / Multiple Spanning Tree Protocol
configuration
The switch supports the IEEE 802.1w Rapid Spanning Tree Protocol (RSTP) and IEEE 802.1s Multiple Spanning Tree
Protocol (MSTP). MSTP allows you to map many VLANs to a small number of spanning tree groups, each with its own
topology.
You can configure up to 32 spanning tree groups on the switch. MRST is turned off by default.
NOTE: When Multiple Spanning Tree is turned on, VLAN 1 is moved from Spanning Tree Group 1 to the
Common Internal Spanning Tree (CIST). When Multiple Spanning Tree is turned off, VLAN 1 is moved back to
Spanning Tree Group 1.
The following table describes the Multiple Spanning Tree Configuration commands.
Table 105 Multiple Spanning Tree Configuration commands
Command Description
[no] spanning-tree mstp
name {<1-32 characters>}
Configures a name for the MSTP region. All devices within a MSTP region must
have the same region name.
Command mode: Global configuration
spanning-tree mstp version
{<0-65535>}
Configures the revision level for the MSTP region. The revision level is used as a
numerical identifier for the region. All devices within a MSTP region must have the
same revision level number. The range is 0-65535.
Command mode: Global configuration
spanning-tree mstp maximum-
hop <4-60>
Configures the maximum number of bridge hops a packet may to traverse before
it is dropped. The range is from 4 to 60 hops. The default is 20.
Command mode: Global configuration
spanning-tree mrst mode
{mst|rstp}
Selects either Rapid Spanning Tree mode (rstp) or Multiple Spanning Tree mode
(mstp). The default mode is RSTP.
Command mode: Global configuration
spanning-tree mrst enable Globally turn RSTP/MSTP ON.
Note: When RSTP is turned on, the configuration parameters for STP group 1
apply to RSTP.
Command mode: Global configuration
no spanning-tree mrst
enable
Globally turn RSTP/MSTP OFF.
Command mode: Global configuration