ProLiant BL p-Class GbE2 Interconnect Switch ISCLI Reference Guide

ISCLI Reference 11
Table 2 User access levels
User account Description and tasks performed
User The User has no direct responsibility for switch management. He or she can view all
switch status information and statistics, but cannot make any configuration changes to
the switch.
The user account is enabled by default, and the default password is user.
Oper The Operator has no direct responsibility for switch management. He or she can view
all switch status information and statistics, but cannot make any configuration
changes to the switch.
By default, the operator account is disabled and has no password.
Admin The super user administrator has complete access to all command modes on the
switch, including the ability to change both the user and administrator passwords.
The admin account is enabled by default, and the default password is admin.
NOTE: With the exception of the admin user, access to each user level can be disabled by setting the
password to an empty value.
Once you enter the administrator password and it is verified, you are given complete access to the switch.
Idle timeout
By default, the GbE2 Interconnect Switch disconnects the console, Telnet, or SSH session after five minutes of
inactivity. This function is controlled by the idle timeout parameter, which can be set from 1 to 60 minutes. To change
this parameter, see the “System configuration” section in the “Configuration Commands” chapter.
Typographical conventions
The following table describes the typographic styles used in this guide:
Typeface or symbol Meaning
angle brackets < > Indicate a variable to enter based on the description inside the brackets. Do not type
the brackets as you enter the command.
Example: If the command syntax is
ping <
IP address>
Enter:
ping 192.32.10.12
bold body text Indicates objects, such as window names, icons, and user-interface objects, such as
buttons and tabs.
bold Courier text Indicates command names, options, and text that you must enter.
Example:
Use the
show ip arp commands.
plain Courier text Indicates command syntax and system output (for example: prompts and system
messages). Example:
configure terminal