ProLiant BL p-Class GbE2 Interconnect Switch ISCLI Reference Guide

Configuration Commands 110
Hot Links Master configuration
The following table describes the Hot Links Master Configuration commands.
Table 120 Hot Links Master Configuration commands
Command Description
[no] hotlinks trigger {<1-4>}
master port <port number (17-24)>
Adds the selected port to the Master interface.
Command mode: Global configuration
[no] hotlinks trigger {<1-4>}
master portchannel <1-12>
Adds the selected trunk to the Master interface.
Command mode: Global configuration
show hotlinks Displays the current Hot Links configuration.
Command mode: All
Hot Links Backup configuration
The following table describes the Hot Links Backup Configuration commands.
Table 121 Hot Links Backup Configuration commands
Command Description
[no] hotlinks trigger {<1-4>}
backup port <port number (17-24)>
Adds the selected port to the Backup interface.
Command mode: Global configuration
[no] hotlinks trigger {<1-4>}
backup portchannel {<1-12>}
Adds the selected trunk to the Backup interface.
Command mode: Global configuration
show hotlinks Displays the current Hot Links configuration.
Command mode: All
VLAN configuration
The commands in this section configure VLAN attributes, change the status of the VLAN, delete the VLAN, and
change the port membership of the VLAN.
By default, the VLANs are disabled except VLAN 1, which is always enabled. The switch supports a maximum of
1,000 VLANs.
NOTE: See the HP ProLiant BL p-Class GbE2 Interconnect Switch Application Guide for information on VLANs.
The following table describes the VLAN Configuration commands.
Table 122 VLAN Configuration commands
Command Description
vlan <1-4095> Enter VLAN configuration mode.
Command mode: Global configuration
name {<1-32 characters>} Assigns a name to the VLAN or changes the existing name. The default
VLAN name is the first one.
Command mode: VLAN configuration
stg {<1-32>} Assigns a VLAN to a spanning tree group.
Command mode: VLAN configuration
member {<port number>} Adds ports to the VLAN membership.
Command mode: VLAN configuration
no member {<port number>} Removes ports from the VLAN membership.
Command mode: VLAN configuration
enable Enables this VLAN.
Command mode: VLAN configuration
no enable Disables this VLAN without removing it from the configuration.
Command mode: VLAN configuration