ProLiant BL p-Class GbE2 Interconnect Switch ISCLI Reference Guide

Configuration Commands 112
Table 124 IP Interface Configuration commands
Command Description
vlan {<1-4095>} Configures the VLAN number for this interface. Each interface can
belong to one VLAN, though any VLAN can have multiple IP
interfaces in it.
Command mode: Interface IP
[no] relay Enables or disables the BOOTP relay on this interface. It is
enabled by default.
Command mode: Interface IP
enable Enables this IP interface.
Command mode: Interface IP
no enable Disables this IP interface.
Command mode: Interface IP
no interface ip {<1-255>} Removes this IP interface.
Command mode: Interface IP
show interface ip {<1-255>} Displays the current interface settings.
Command mode: All
NOTE: If you enter an IP address for interface 1, you are prompted to change the BOOTP setting.
Default Gateway configuration
The switch supports up to four gateways. By default, no gateways are configured on the switch. Enter 1, 2, 3, or 4 in
the command as the <gateway instance>, depending upon which gateway you want to configure.
The following table describes the Default IP Gateway Configuration commands.
Table 125 Default IP Gateway Configuration commands
Command Description
ip gateway {<1-4>} address {<IP
address>}
Configures the IP address of the default IP gateway, using dotted decimal
notation.
Command mode: Global configuration
ip gateway {<1-4>} interval
{<0-60>}
The switch pings the default gateway to verify that it is up. This option sets
the time between health checks. The range is from 0 to 60 seconds. The
default is 2 seconds.
Command mode: Global configuration
ip gateway {<1-4>} retry {<1-
120>}
Sets the number of failed health check attempts required before declaring
this default gateway inoperative. The range is from 1 to 120 attempts. The
default is 8 attempts.
Command mode: Global configuration
[no] ip gateway {<1-4>} arp-
health-check
Enables or disables Address Resolution Protocol (ARP) health checks. This
command is disabled by default.
Command mode: Global configuration
ip gateway {<1-4>} enable Enables the gateway for use.
Command mode: Global configuration
no ip gateway {<1-4>} enable Disables the gateway.
Command mode: Global configuration
no ip gateway {<1-4>} Deletes the gateway from the configuration.
Command mode: Global configuration
show ip gateway {<1-4>} Displays the current gateway settings.
Command mode: All except User EXEC