ProLiant BL p-Class GbE2 Interconnect Switch ISCLI Reference Guide

Configuration Commands 116
Table 132 Autonomous System Path Configuration commands
Command Description
show route-map <1-32> as-path-
list {<1-8>}
Displays the current Autonomous System filter configuration.
Command mode: All except User EXEC
Routing Information Protocol configuration
The RIP Menu is used for configuring Routing Information Protocol parameters. This option is turned off by default.
The following table describes the basic RIP Configuration commands. The following section provides more detailed
information and commands.
Table 133 RIP Configuration commands
Command Description
router rip Enter router RIP configuration mode.
Command mode: Global configuration
timers update {<1-120>} Configures the time interval for sending for RIP table updates, in seconds.
The default value is 30 seconds.
Command mode: Router RIP
enable Globally turns RIP on.
Command mode: Router RIP
no enable Globally turns RIP off.
Command mode: Router RIP
show ip rip Displays the current RIP configuration.
Command mode: All except User EXEC
RIP Interface configuration
The RIP commands are used for configuring Routing Information Protocol parameters. This option is turned off by
default.
NOTE: Do not configure RIP1 parameters if your routing equipment uses RIP version 2.
The following table describes the RIP Interface Configuration commands.
Table 134 RIP Interface Configuration commands
Command Description
ip rip version {1|2|both} Configures the RIP version used by this interface.
The default value is version
2.
Command mode: Interface IP
[no] ip rip supply When enabled, the switch supplies routes to other routers. This command is
enabled by default.
Command mode: Interface IP
[no] ip rip listen When enabled, the switch learns routes from other routers. This command is
enabled by default.
Command mode: Interface IP
[no] ip rip poison When enabled, the switch uses split horizon with poisoned reverse. When
disabled, the switch uses only split horizon. This command is disabled by
default.
Command mode: Interface IP
[no] ip rip split-horizon Enables or disables split horizon. The default value is enabled.