ProLiant BL p-Class GbE2 Interconnect Switch ISCLI Reference Guide

Configuration Commands 117
Table 134 RIP Interface Configuration commands
Command Description
[no] ip rip triggered Enables or disables Triggered Updates. Triggered Updates are used to speed
convergence. When enabled, Triggered Updates force a router to send update
messages immediately, even if it is not yet time for the update message. The
default value is
disabled.
Command mode: Interface IP
[no] ip rip multicast-
updates
Enables or disables multicast updates of the routing table (using address
224.0.0.9). The default value is
enabled.
Command mode: Interface IP
[no] ip rip default-action
{both|listen|supply}
When enabled, the switch accepts RIP default routes from other routers, but
gives them lower priority than configured default gateways. When disabled,
the switch rejects RIP default routes. This command is disabled by default.
Command mode: Interface IP
[no] ip rip metric {<1-15>} Configures the route metric, which indicates the relative distance to the
destination. The default value is
1.
Command mode: Interface IP
[no] ip rip authentication
type {<password>}
Configures the authentication type. The default is none.
Command mode: Interface IP
ip rip authentication key
{<password>}
Configures the authentication key password.
Command mode: Interface IP
ip rip enable Enables this RIP interface.
Command mode: Interface IP
no ip rip enable Disables this RIP interface.
Command mode: Interface IP
show interface ip [<1-255>]
rip
Displays the current RIP configuration.
Command mode: All except User EXEC
Open Shortest Path First configuration
The following table describes the basic Open Shortest Path First commands. The following sections provide more
detailed information and commands.
Table 135 OSPF Configuration commands
Command Description
router ospf Enter Router OSPF configuration mode.
Command mode: Router OSPF
area <0-2> Configures the OSPF area.
Command mode: Router OSPF
area-range <0-16> Configures the summary range.
Command mode: Router OSPF
ip ospf <1-255)> Configures the OSPF interface.
Command mode: Interface IP
area-virtual-link <1-3> Configures a Virtual Link.
Command mode: Router OSPF
message-digest-key <1-255> md5-
key <key string>
Assigns a string to MD5 authentication key.
Command mode: Router OSPF
host <1-128> Configures an OSPF host route. Up to 128 host routes can be
configured. Host routes are used for advertising network device IP
addresses to external networks to perform server load balancing within
OSPF. It also makes Area Border Route (ABR) load sharing and ABR
failover possible.
Command mode: Router OSPF