ProLiant BL p-Class GbE2 Interconnect Switch ISCLI Reference Guide

Configuration Commands 120
Table 138 OSPF Interface Configuration commands
Command Description
ip ospf transit-delay
<1-3600>
Configures the transit delay in seconds.
Command mode: Interface IP
ip ospf retransmit-interval
<1-3600>
Configures the retransmit interval in seconds.
Command mode: Interface IP
[no] ip ospf key <key
string>
Sets the authentication key to clear the password.
Command mode: Interface IP
[no] ip ospf message-digest-
key <1-255>
Assigns an MD5 key to the interface.
Command mode: Interface IP
ip ospf enable Enables the OSPF interface.
Command mode: Interface IP
no ip ospf enable Disables the OSPF interface.
Command mode: Interface IP
no ip ospf Deletes the OSPF interface.
Command mode: Interface IP
show interface ip ospf
{<1-255>}
Displays the current settings for OSPF interface.
Command mode: All except User EXEC
OSPF Virtual Link configuration
The following table describes the OSPF Virtual Link Configuration commands.
Table 139 OSPF Virtual Link Configuration commands
Command Description
area-virtual-link <1-3> area <0-2> Configures the OSPF area index.
Command mode: Router OSPF
area-virtual-link <1-3> hello-interval
<1-65535>
Configures the authentication parameters of a hello packet, which is
set to be in an interval of seconds.
Command mode: Router OSPF
area-virtual-link <1-3> dead-interval
<1-65535>
Configures the health parameters of a hello packet, which is set to be
in an interval of seconds. Default is 40 seconds.
Command mode: Router OSPF
area-virtual-link <1-3> transit-delay
<1-3600>
Configures the delay in transit in seconds. Default is one second.
Command mode: Router OSPF
area-virtual-link <1-3> retransmit-
interval <1-3600>
Configures the retransmit interval in seconds. Default is five seconds.
Command mode: Router OSPF
area-virtual-link <1-3> neighbor-
router <IP address>
Configures the router ID of the virtual neighbor. Default is 0.0.0.0
Command mode: Router OSPF
[no] area-virtual-link <1-3> key <key
string>
Configures the password (up to eight characters) for each virtual link.
Default is
none.
Command mode: Router OSPF
area-virtual-link <1-3> message-
digest-key <1-255>
Sets MD5 key ID for each virtual link. Default is none.
Command mode: Router OSPF
area-virtual-link <1-3> enable Enables OSPF virtual link.
Command mode: Router OSPF
no area-virtual-link <1-3> enable Disables OSPF virtual link.
Command mode: Router OSPF
no area-virtual-link <1-3> Deletes OSPF virtual link.
Command mode: Router OSPF
show ip ospf area-virtual-link <1-3> Displays the current OSPF virtual link settings.
Command mode: All except User EXEC