ProLiant BL p-Class GbE2 Interconnect Switch ISCLI Reference Guide

Configuration Commands 133
Table 161 TCP/UDP Filter Configuration commands
Command Description
access-control list <1-4096>
tcp-udp destination-port
<1-65535> {<port mask>}
Defines a destination port for the ACL. If defined, traffic with the specified TCP
or UDP destination port will match this ACL. Specify the port number, just as
with
source-port above.
Command mode: Global configuration
access-control list <1-4096>
tcp-udp flags <value
(0x0-0x3f)>
Defines a TCP/UDP flag for the ACL.
Command mode: Global configuration
default access-control list
<1-4096> tcp-udp
Resets the TCP/UDP parameters for the ACL to their default values.
Command mode: Global configuration
show access-control list
[<1-4096>] tcp-udp
Displays the current TCP/UDP Filtering parameters.
Command mode: All except User EXEC
ACL Packet Format configuration
The following table describes the Packet Format Configuration commands.
Table 162 Packet Format Configuration commands
Command Description
access-control list <1-4096>
packet-format ethernet
{ethertype2|snap|llc}
Defines the Ethernet format for the ACL.
Command mode: Global configuration
[no] access-control list <1-4096>
packet-format tagged
Defines the tagging format for the ACL.
Command mode: Global configuration
default access-control list
<1-4096> packet-format
Resets Packet Format parameters for the ACL to their default values.
Command mode: Global configuration
show access-control list <1-4096>
packet-format
Displays the current Packet Format parameters for the ACL.
Command mode: All except User EXEC
ACL Block configuration
These commands allow you to compile one or more ACLs into an ACL Block. Each ACL in the ACL Block must fall
within the same mask.
The following table describes the ACL Block Configuration commands.
Table 163 ACL Block Configuration commands
Command Description
access-control block <block
(1-4096)> <ACL (1-4096)>
Adds the selected ACL to the ACL Block.
Command mode: Global configuration
no access-control block
<block (1-4096)> <ACL
(1-4096)>
Removes the selected ACL from the ACL Block.
Command mode: Global configuration
show access-control block
<1-4096>
Displays the current ACL block parameters.
Command mode: All except User EXEC