ProLiant BL p-Class GbE2 Interconnect Switch ISCLI Reference Guide

Configuration Commands 139
Saving the active switch configuration
When the copy running-Global configuration tftp command is used, the active configuration commands
of the switch will be uploaded to the specified script configuration file on the TFTP server. To start the switch
configuration upload, at the prompt, enter:
Switch(config)# copy running-config startup-config
NOTE: The output file is formatted with line-breaks but no carriage returns. The file cannot be viewed with
editors that require carriage returns (such as Microsoft Notepad).
NOTE: If the TFTP server is running SunOS™ or the Solaris™ operating system, the specified file must exist
prior to executing the copy running-config tftp command and must be writable (set with proper
permission, and not locked by any application). The contents of the specified file will be replaced with the
current configuration data.
Restoring the active switch configuration
When the tftp running-config command is used, the active configuration will be replaced with the commands
found in the specified configuration file. The file can contain a full switch configuration or a partial configuration.
To start the switch configuration download, at the prompt, enter:
Switch(config)# copy {tftp|ftp} running-config
NOTE: The switch supports three configuration files: active, backup, and factory. See the “Selecting a
configuration block” section in the “Boot Options” chapter for information on how to set which configuration
file to use upon boot up.