ProLiant BL p-Class GbE2 Interconnect Switch ISCLI Reference Guide

Boot Options 145
Resetting the switch
You can reset the switch to make your software image file and configuration block changes occur.
Resetting the switch causes the Spanning Tree Protocol to restart. This process can be lengthy, depending on the
topology of your network.
To reset the switch, at the prompt, enter:
>> Switch# reload
You are prompted to confirm your request.
To display current boot options, enter:
>> Switch# show boot
Accessing the AOS CLI
To access the AOS CLI, enter the following command from the ISCLI, and reload the switch:
>> Switch# boot cli-mode aos
The default command-line interface for the GbE2 Interconnect Switch is the AOS CLI. To access the ISCLI, enter the
following command and reset the GbE2:
Main# boot/mode iscli
Users can select the CLI mode upon login, if the boot cli-mode prompt command is issued. Only an
administrator connected through the console port can view and enable prompt. When prompt is enabled, the first
user to log in can select either the CLI mode. Subsequent users must use the selected CLI mode, until all users have
logged out.