ProLiant BL p-Class GbE2 Interconnect Switch ISCLI Reference Guide

Information Commands 33
Table 22 802.1x information
Field Description
Backend Auth State Displays the Backend Authorization State. The Backend Authorization state
can be one of the following:
• request
• response
• success
• fail
• timeout
• idle
The following table describes the IEEE 802.1p port priority information.
Table 23 802.1p Port Priority information
Command Usage
Port Displays the port number.
Priority Displays the 802.1p Priority level.
Cosq Displays the Class of Service queue.
Weight Displays the scheduling weight.
Spanning Tree information
The following command displays Spanning Tree information:
show spanning-tree stp <1-32> information
Command mode: All
------------------------------------------------------------------
upfast disabled, update 40
------------------------------------------------------------------
Spanning Tree Group 1: On (STP/PVST+)
VLANs: 1
Current Root: Path-Cost Port Hello MaxAge FwdDel Aging
8000 00:02:a5:d1:0f:ed 8 20 2 20 15 180
Parameters: Priority Hello MaxAge FwdDel Aging
32768 2 20 15 180
Port Priority Cost FastFwd State Designated Bridge Des Port
---- -------- ---- -------- ---------- --------------------- -------
1 0 0 n FORWARDING *
2 0 0 n FORWARDING *
3 0 0 n FORWARDING *
The switch software uses the IEEE 802.1d Spanning Tree Protocol (STP). If RSTP/MSTP is turned on, see the “Rapid
Spanning Tree information” section for Spanning Tree Group information. In addition to seeing if STP is enabled or
disabled, you can view the following STP bridge information:
• Status of Uplink Fast (upfast)
• Current root MAC address
• Path cost
• Port
• Hello interval
• Maximum age value
• Forwarding delay
• Aging time