ProLiant BL p-Class GbE2 Interconnect Switch ISCLI Reference Guide

Information Commands 40
Layer 3 information
The following table describes basic Layer 3 Information commands. The following sections provide more detailed
information and commands. Layer 3 functionality is limited in this release.
Table 27 Layer 3 information commands
Command Usage
show ip route Displays all routes configured in the switch.
Command mode: All except User EXEC
show ip arp Displays Address Resolution Protocol (ARP) Information.
Command mode: All except User EXEC
show ip ospf information Displays the OSPF information.
Command mode: All except User EXEC
show interface ip rip Displays RIP user’s configuration.
Command mode: All
show layer3 information Displays IP Information. IP information, includes:
• IP interface information: Interface number, IP address, subnet mask, VLAN
number, and operational status.
• Default gateway information: Metric for selecting which configured gateway
to use, gateway number, IP address, and health status
• IP forwarding information: Enable status, lnet and lmask
• Port status
Command mode: All except User EXEC
show ip igmp groups Displays IGMP Information.
Command mode: All except User EXEC
show ip vrrp information Displays the VRRP Information.
Command mode: All except User EXEC
show layer3 Dumps all switch information available from Layer 3 memory (10K or more,
depending on your configuration).
If you want to capture dump data to a file, set your communication software on
your workstation to capture session data prior to issuing the dump commands.
Command mode: All except User EXEC
Route information
Using the commands listed below, you can display all or a portion of the IP routes currently held in the switch.
Table 28 Route Information commands
Command Usage
show ip route address <IP address> Displays a single route by destination IP address.
Command mode: All except User EXEC
show ip route gateway <IP address> Displays routes to a single gateway.
Command mode: All except User EXEC
show ip route type
{indirect|direct|local|broadcast|mart
ian|multicast}
Displays routes of a single type.
Command mode: All except User EXEC
show ip route tag
{fixed|static|addr|rip|ospf|broadcast
|multicast|martian}
Displays routes of a single tag.
Command mode: All except User EXEC
show ip route interface <1-255> Displays routes on a single interface.
Command mode: All except User EXEC
show ip route Displays all routes configured in the switch.
Command mode: All except User EXEC