ProLiant BL p-Class GbE2 Interconnect Switch ISCLI Reference Guide

Statistics commands 56
Statistics commands
Introduction
You can view switch performance statistics in the user, operator, and administrator command modes. This chapter
discusses how to use the ISCLI to display switch statistics.
The following table describes general Statistics commands.
Table 41 Statistics commands
Command Usage
show layer2 counters Displays Layer 2 Statistics.
Command mode: All
show layer3 counters Displays Layer 3 Statistics.
Command mode: All
show snmp-server counters Displays SNMP statistics.
Command mode: All
show ntp counters Displays Network Time Protocol (NTP) Statistics.
You can execute the clear command option to delete all statistics.
Command mode: All
show ufd counters Displays Uplink Failure Detection statistics.
Command mode: All
show counters
Dumps all switch statistics. Use this command to gather data for
tuning and debugging switch performance. If you want to capture
dump data to a file, set your communication software on your
workstation to capture session data prior to issuing the dump
command.
Command mode: All
Port Statistics
The following table describes the Port Statistics commands. The following sections provide more detailed information
and commands.
Table 42 Port Statistics commands
Command Usage
show interface port <port number>
dot1x counters
Displays IEEE 802.1x statistics for the port.
Command mode: All
show interface port <port number>
bridging-counters
Displays bridging (“dot1”) statistics for the port.
Command mode: All
show interface port <port number>
ethernet-counters
Displays Ethernet (“dot3”) statistics for the port.
Command mode: All
show interface port <port number>
interface-counters
Displays interface statistics for the port.
Command mode: All
show interface port <port number>
ip-counters
Displays Internet Protocol statistics for the port.
Command mode: All
show interface port <port number>
link-counters
Displays link statistics for the port.
Command mode: All