ProLiant BL p-Class GbE2 Interconnect Switch ISCLI Reference Guide

Configuration Commands 95
Port link configuration
Use these commands to set port parameters for the port link.
Link commands are described in the following table. Using these commands, you can set port parameters such as
speed, duplex, flow control, and negotiation mode for the port link.
The following table describes the Gigabit Link Configuration commands.
Table 94 Gigabit Link Configuration commands
Command Description
speed {10|100|1000|auto} Sets the link speed. Not all options are valid on all ports. The choices include:
• 10 Mb/s
• 100 Mb/s
• 1000 Mb/s
• “auto,” for automatic detection (default)
Note: Ports 1-18 are set to 1000 Mb/s, and cannot be changed.
Command mode: Interface port
duplex {full|half|any} Sets the operating mode. Not all options are valid on all ports. The choices
include:
• Full-duplex
• Half-duplex
• “Any,” for automatic detection (default)
Note: Ports 1-18 are set to full duplex, and cannot be changed.
Command mode: Interface port
flowcontrol
{receive|send|both}
Sets the flow control. The choices include:
• Receive (rx) flow control
• Transmit (tx) flow control
• Both receive and transmit flow control (default)
Command mode: Interface port
no flowcontrol Sets the flow control to none.
Command mode: Interface port
[no] auto Enables or disables auto-negotiation for the port.
Command mode: Interface port
show interface port {<port
number>}
Displays current port parameters.
Command mode: All
ACL Port configuration
The following table describes the basic Access Control List Configuration commands for the port.
Table 95 ACL Port Configuration commands
Command Description
[no] access-control list <1-4096> Adds or removes the specified ACL. You can add multiple ACLs to a
port, but the total number of precedence levels allowed is seven.
Command mode: Interface port
[no] access-control block <1-4096> Adds or removes the specified ACL Block. You can add multiple ACL
Blocks to a port, but the total number of precedence levels allowed is
seven.
Command mode: Interface port
[no] access-control group <1-4096> Adds or removes the specified ACL Group. You can add multiple
ACL Groups to a port, but the total number of precedence levels
allowed is seven.
Command mode: Interface port
show interface port [<port number>]
access-control
Displays current ACL QoS parameters.
Command mode: All