ProLiant BL p-Class GbE2 Interconnect Switch ISCLI Reference Guide

Configuration Commands 96
ACL Port Metering configuration
The following table describes the ACL Port Metering Configuration commands.
Table 96 ACL Port Metering Configuration commands
Command Description
access-control meter <1-63>
committed-rate <1000-1000000>
Configures the committed rate, in Kilobits per second. The committed rate
must be a multiple of 64.
Command mode: Interface port
access-control meter <1-63>
maximum-burst-size <32-4096>
Configures the maximum burst size, in Kilobits. Enter one of the following
values for
mbsize: 32, 64, 128, 256, 512, 1024, 2048, 4096
Command mode: Interface port
[no] access-control meter <1-63>
enable
Enables or disables ACL Metering on the port.
Command mode: Interface port
access-control meter <1-63>
action {drop|pass}
Configures the ACL Meter to either drop or pass out-of-profile traffic.
Command mode: Interface port
access-control meter <1-63>
{list|block|group} <1-4096>
Adds an ACL, ACL Block, or ACL Group to the ACL Meter on this port.
Command mode: Interface port
no access-control meter <1-63>
{list|block|group} <1-4096>
Removes an ACL, ACL Block, or ACL Group from the ACL Meter on this
port.
Command mode: Interface port
default access-control meter <1-
63>
Reset ACL Metering parameters to their default values.
Command mode: Interface port
show interface port {<port
number>} access-control meter
{<1-63>}
Displays current ACL Metering parameters.
Command mode: All
ACL Port Re-mark configuration
You can choose to re-mark IP header data for the selected ACL Group on the port. You can configure different re-
mark values, based on whether packets fall within the ACL Metering profile, or out of the ACL Metering profile.
The following table describes the ACL Port Re-mark Configuration commands.
Table 97 ACL Port Re-mark Configuration commands
Command Description
[no] access-control re-mark <1-63>
list <1-4096>
Assign an ACL for DSCP re-marking on this port.
Command mode: Interface port
[no] access-control re-mark <1-63>
block <1-4096>
Assign an ACL Block for DSCP re-marking on this port.
Command mode: Interface port
[no] access-control re-mark <1-63>
group <1-4096>
Assign an ACL Group for DSCP re-marking on this port.
Command mode: Interface port
default access-control re-mark <1-
63>
Reset ACL Re-mark parameters to their default values.
Command mode: Interface port
show interface port {<port number>}
access-control re-mark {<1-63>}
Displays current Re-mark parameters.
Command mode: All