ProLiant BL p-Class GbE2 Interconnect Switch ISCLI Reference Guide

Configuration Commands 97
ACL Port Re-Mark In-Profile configuration
The following table describes the ACL Port Re-Mark In-Profile Configuration commands.
Table 98 ACL Port Re-Mark In-Profile Configuration commands
Command Description
access-control re-mark <1-63>
in-profile dscp <0-63>
Sets the DiffServ Code Point (DSCP) of In-Profile packets to the selected
value.
Command mode: Interface port
default access-control re-mark
<1-63>
Resets the update DSCP parameters to their default values.
Command mode: Interface port
show interface port {<port
number>} access-control re-mark
{<1-63>}
Displays current Re-mark parameters.
Command mode: All
Re-Mark Update User Priority configuration
The following table describes the Update User Priority Configuration commands.
Table 99 ACL Port Update User Priority Configuration commands
Command Description
access-control re-mark <1-63>
in-profile dot1p <0-7>
Defines 802.1p value. The value is the priority bits information in the packet
structure.
Command mode: Interface port
[no] access-control re-mark
<1-63> in-profile use-tos-
precedence
Enable or disable mapping of TOS (Type of Service) priority to 802.1p
priority for In-Profile packets. When enabled, the TOS value is used to set the
802.1p value.
Command mode: Interface port
default access-control re-
mark <1-63>
Resets UP1P settings to their default values.
Command mode: Interface port
show interface port {<port
number>} access-control re-
mark {<1-63>}
Displays current Re-mark parameters.
Command mode: All
ACL Port Re-Mark Out-of-Profile configuration
The following table describes the Re-Mark Out-of-Profile Configuration commands.
Table 100 ACL Port Re-Mark Out-of-Profile Configuration commands
Command Description
access-control re-mark <1-63>
out-profile dscp <0-63>
Sets the DiffServ Code Point (DSCP) of Out-of-Profile packets to the selected
value. The switch sets the DSCP value on Out-of-Profile packets.
Command mode: Interface port
default access-control re-
mark <1-63>
Resets the update DSCP parameters for Out-of-Profile packets to their default
values.
Command mode: Interface port
show interface port {<port
number>} access-control re-
mark {<1-63>}
Displays current Re-mark parameters.
Command mode: All