HP ProLiant BL35p Server Blade User Guide

Operations 13
IMPORTANT: When the server blade is in standby mode, auxiliary power is still being provided. To
remove all power from the server blade, remove the server blade from the server blade enclosure. Removing
the sleeve from the server blade enclosure is not necessary.
IMPORTANT: Remote power procedures require the most recent firmware for the power enclosure and
server blade enclosure management modules. For the most recent firmware, refer to the HP website
(http://www.hp.com/go/support
).
Remove the server blade
1. Back up all server blade data.
2. Power down the server blade (on page 12).
3. Remove the server blade from the HP BladeSystem p-Class sleeve.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and
the internal system components to cool before touching them.
CAUTION: To prevent damage to electrical components, properly ground the server blade before
beginning any installation procedure. Improper grounding can cause ESD.