HP Scripting Toolkit 9.60 for Windows User Guide

DescriptionCommand-line argument
Your input or current value when read from HBA
BootDeviceWWID=22334455
Your input, default LUN, or current value when read from
HBA
BootDeviceLUN[0]=1111
HPLPCFG return codes
MeaningValue
The command was completed successfully.
0
There was an invalid command line option.
1
There was a file open error.
2
There was an NVRAM checksum error.
3
There was an NVRAM data error.
4
There was no adapter or Emulex HBA found on this host.
5
There was an error retrieving the I/O address.
6
The WWID was invalid because of one of the following:
7
• An invalid value for WWID and BootDeviceWWID, and not a hex value
• The WWID specified for HBA in the .ini file does not match any HBAs found on the host (for the
/l option only)
The LUN was invalid.
8
Invalid value; for enable/disable value is not 0 or 1 (for /l option only)
0x10
Incorrect iboot BIOS code loaded (for /l option only)
0x11
General error:
0xFF
• Initialization error (for both /l and /s option)
• Cannot read HBAs WWPN (for /s option only)
HPLPCFG command-line examples
hplpcfg –s hba.ini generates hba.iniwith the following content:
[HBA0]
WWID=11111111
HostAdapterBiosEnable=1
SelectBootEnable=1
BootDeviceWWID=
BootDeviceLUN[0]=
You must edit hba.ini and add the following boot device information:
[HBA0]
WWID=11111111
HostAdapterBiosEnable=1
SelectBootEnable=1
BootDeviceWWID=22222222
BootDeviceLUN[0]=3
46 Scripting Toolkit utilities