Emulex OneCommand Manager Application User Manual (P006979-01A Version 5.2, August 2011)

The OneCommand Manager User Manual Page 139
Figure 81: Delete Virtual Port Warning
4. Check It is OK to delete the virtual port and click OK. You are notified that the virtual port is no
longer available and that it was removed from the discovery-tree.
5. Click OK.
Using FC-SP DHCHAP Authentication (Windows, Linux 8.2
and Solaris)
Use the DHCHAP tab to view and configure FC-SP DHCHAP (Diffie-Hellmann Challenge Handshake
Authentication Protocol). You can authenticate an adapter to a switch.
Once DHCHAP has been activated and configured, manually initiate authentication per adapter by
clicking on the Initiate Authentication button or by inducing a fabric login (FLOGI) time per the FC-SP
standard to the switch. A FLOGI can also be caused by bringing the link between the switch and adapter
down and then up. (Not available in read-only mode.)
Note: The link on the physical port must be up to delete a virtual port. The Remove Virtual
Port button on the Virtual Port tab is disabled if the link is down.
Note: DHCHAP is available only for physical ports, not for virtual ports.
Note: DHCHAP is not supported on COMSTAR ports.
Note: DHCHAP is not supported on RHEL6+ and SLES11-SP1+.
Note: DHCHAP is not supported on OneConnect adapters.