Emulex OneCommand Manager Application User Manual (P006979-01A Version 5.2, August 2011)

The OneCommand Manager User Manual Page 161
3. Select the Maintenance tab, check enable adapter boot (if available) and click Configure
Boot. The Boot from SAN Configuration dialog box appears.
Figure 95: Boot from SAN Configuration dialog box
The Boot from SAN Configuration dialog box varies for each boot type. Figure 95 depicts the
boot from SAN configuration for the x86 type boot.
4. Verify the adapter address and boot version to make sure you configure the correct adapter and
that it has the boot code version you want.
5. From the Boot Type menu, select x86, EFIBoot or OpenBoot.
Note: The Configure Boot button is disabled if the Enable Adapter Boot checkbox is not
checked. If boot code is not present on the adapter, the Enable Adapter Boot
checkbox and Configure Boot button are not displayed on the Maintenance tab.
Note: For OneConnect adapters, boot is always enabled and cannot be disabled.
Note: x86 and OpenBoot share the same configuration memory space. You cannot
configure an adapter for both x86 and OpenBoot at the same time. When you select
one of these boot types and the configuration region is configured for the other boot
type, a message appears warning that making changes overwrites the other boot-
type configuration.
Note: If you modified the settings for the current boot type and then change to a new boot
type, a message appears telling you to save the current settings before changing to
the new boot type.