Emulex OneCommand Manager Application User Manual (P006979-01A Version 5.2, August 2011)

The OneCommand Manager User Manual Page 163
Figure 96: Select Boot Device window (for x86 or EFIBoot)
10. On the Boot from SAN Configuration dialog box, click Apply to save your changes, but leave
the dialog box open or click OK to apply the changes and close the dialog box.
11. Reboot the system for your changes to take effect.
Configuring Advanced Settings (Boot from SAN)
The OneCommand Manager application provides advanced settings for each boot type. From the Boot
from SAN Configuration dialog box, click Advanced Settings. A boot type-specific dialog box allows
you to enable options such as spinup delay and autoscan. If you do not use advanced settings, the
default values are used.
Note: Click Close to close the Boot from SAN Configuration dialog box without saving your
changes. A message appears to discard your changes.