Emulex OneCommand Manager Application User Manual (P006979-01A Version 5.2, August 2011)

The OneCommand Manager User Manual Page 168
Diagnostics
LightPulse FC Diagnostics
This section describes the diagnostics available for LightPulse FC adapters. For OneConnect adapter
diagnostics, see “OneConnect Diagnostics” on page 178.
Use the Diagnostics tab to:
• View flash load list, PCI registers and wakeup parameter information.
• Run these tests on Emulex adapters installed in the system: (Not available in read-only mode.)
• PCI Loopback
• Internal Loopback
• External Loopback
• Power-On Self Test (POST)
• Echo (End-to-End)
• Quick Test
• Perform a diagnostic dump and retrieve dump files from remote hosts. (Not available in read-
only mode.)
• Control adapter beaconing (Not available in read-only mode.)
All functions are supported locally and remotely on hosts managed with TCP/IP access.
Note: Diagnostic tests can only be performed on a local adapter or on a remote adapter
connected via TCP/IP. Diagnostic tests cannot be performed on remote adapters
connected via FC.
Note: Diagnostic dumps can only be generated for local LightPulse adapters or for remote
LightPulse adapters connected via TCP/IP. Diagnostic dumps cannot be generated
for remote adapters connected via FC.
Note: Not supported on systems using CIM provider v1.2.1 on ESX 3i. and only partially
supported on systems using CIM provider v2.0 on ESXi 4.x.
Note: Quick Test, POST Test, and the Advanced Diagnostic Test buttons are disabled for
any remote adapter that is managed in-band.
Note: Diagnostics are not supported on COMSTAR ports.