Emulex OneCommand Manager Application User Manual (P006979-01A Version 5.2, August 2011)

The OneCommand Manager User Manual Page 173
Figure 104: Diagnostic Dump File Transfer dialog box
6. Select the files you want to copy (multiple selections are available) and click Start Copy. The
remote dump files will be copied to your local Dump folder. The local dump folder locations are
described in step 4.
Running Advanced Diagnostic Tests
The Advanced Diagnostics feature gives you greater control than the Quick Test over the type of
diagnostics tests that run. Through Advanced Diagnostics, you can specify which tests to run, the
number of cycles to run and what to do in the event of a test failure. (Not available in read-only mode or
on LightPulse adapters in ESXi hosts.)
To run advanced diagnostics tests:
Click Advanced Diagnostic Tests on the Diagnostics tab to view the Diagnostic Test Setup dialog box.
You can run four types of tests:
• PCI Loopback
• Internal Loopback
• External Loopback
• End-to-End (ECHO)
Note: Internal and External Loopback tests are not available for LP21000 and LP21002
adapters.
Note: You cannot run the External Loopback test and ECHO test concurrently. If you select
External Loopback the ECHO test section is disabled and vice versa.